Switcher

2x1 (1 input at transmitter plus 1 input at receiver x 1 output at receiver) auto-switching or manual, audio-follows-video, Auto- Locking.

Scaler, HDMI Output

4K video scaler with intelligent frame rate conversion, Deep Colour support, content adaptive noise reduction, 3:2/2:2 pulldown detection and recovery

Input Signal Type

HDMI with Deep Colour and 4K (DVI and Dual Mode DisplayPort interface compatible2

Output Signal Typе

HDMI with Deep Colour and 4K (DVI compatible)

Copy Protection

HDCP 2.2

Audio

Input Signal Type

HDMI (Dual-Mode DisplayPort interface compatible2)

Output Signal Type

HDMI, analog stereo line-level

Digital Formats

2-channel LPCM

Digital to Analog Conversion

24-bit, 48 kHz

Output Volume

a. -80 to +20 dB level adjustment range; Independent mute for HDMI and analog audio outputs.

Analog Output Performance

Frequency Response: 20 Hz to 20 kHz ±0.5 dB; S/N Ratio: >95 dB '10 dBV, 20 Hz to 20 kHz, A-weighted; THD+N: <0.005%' 1 kHz and 10 dBV; Stereo Separation: 20 Hz to 20 kHz ≤80 dB

Communications

Ethernet

100/1000 Mbps, auto switching, auto negotiating, auto discovery, full/half duplex, CIP, DHCP, web browser setup and control

RS-232

Two-way device control and monitoring up to 115.2k baud; Hardware and software handshaking

IR

One way device control via infrared up to 60 kHz

HDMI

HDCP 2.2, EDID, СЕС

DM

HDCP 2.2, EDID

Connectors - Transmitter

24 VDC 1.25A

2.1 x 5.5 mm DC power connector; 24VDC power input;

DM

8-pin RJ-45 connector, female, shielded; DM output port for connection to the receiver1

HDMI IN

HDMI Type A connectors, female; HDMI digital video/audio input; DVI and Dual-Mode Display Port interface compatible2

COM

5-pin 3.5 mm detachable terminal block; Bidirectional RS-232 port; Supports RS-232 up to 115.2k baud; Hardware and software handshaking.

IR IN/OUT

4-pin 3.5 mm detachable terminal block; Comprised of (1) IR input port and (1) IR output port

Connectors - Receiver

HDMI INPUT 1

HDMI Type A connector, female; HDMI digital video/audio input; DVI and Dual-Mode Display Port interface compatible

DM INPUT 2

8-pin RJ-45, female, shielded; DM link port for connection to the transmitter.

HDMI OUTPUT

HDMI Type A connector, female; HDMI digital video/audio output (DVI compatible)

AUDIO L/R

5-pin 3.5 mm_ detachable terminal block; Balanced /unbalanced stereo line-level audio output; Maximum Output Level: 4Vrms balanced 2Vrms unbalanced; Output Impedance: 2000 balanced,
1000 unbalanced.

Ethernet

8-pin RJ-45 connector, female; 100 BASE-TX/1000BASE-T Ethernet port

I/O 1-2 (2)

2-pin detachable terminal blocks; Comprised of 2 Versiport digital input/ output or analog input ports (referenced to GND); Digital Input: Rated to 0-24VDC, input impedance 20kΩ, logic threshold >3.125V low/0 and <1.875V high/1; Digital Output: 250 mA sink from maximum 24VDC, catc diodes for use with real world loads: Analog Input: Rated for 0-10VDC, protected to 24VDC maximum. input impedance 21kO with pull-up resistor disabled; Programmable 5V, 2k pull-up resistor per pin.

RELAY 1-2

2-pin detachable terminal blocks; Comprised of 2 normally open, isolated relays; Rated 1A, 30VAC/ VDC; MOV arc suppression across contacts

Controls and Indicators - Transmitter

LINK

LED indicates that DM link is established

PWR

bi-color LED

HDMI IN

Green LED

DM OUT

(LEDs on RJ-45 connector

Controls and Indicators - Receiver

Power

bi-color LED

INPUT 1-2

Push buttons for manual input selection and (2) LEDs.

AUTO

Push button to enable or disable automatic switching

SETUP

Red LED and push button for display of IP address on the HDMI output

DM

LEDs on RJ-45 connector

Ethernet

LEDs on RJ-45 connector

Power Pack

Input: 100-240VAC;
Output: 24VDC 2.5A

Power Consumption

14.8 W typical

Temperature

32° to 104° F (0° to 40° C)

Heat Dissipation

50.5 BTU/hr

Humidity

Transmitter: 20% to 90% RH (noncondensing);
Receiver: 10% to 90% RH (non-condensing)

Warranty

3 years

Power Pack

Input: 100-240VAC; Output: 24VDC 7.5A;

Temperature

32° to 104° F (0° to 40° C)

Humidity

Transmitter: 20% to 90% RH (noncondensing);
Receiver: 10% to 90% RH (non-condensing)

Warranty

3 Years