Control Engine

4-Series; real-time, pre-emptive multithreaded/ multitasking kernel;
Transaction-Safe Extended FAT file system; supports up to 10 simultaneously running programs

Communications

Ethernet

100/1000 Mbps, auto-switching, auto-negotiating, auto-discovery, full/half duplex, industry-standard TCP/IP stack, UDP/IP, CIP, DHCP. SSL, TLS, SSH, SFTP (SSH File Transfer Protocol), FIPS 140-2 compliant encryption, IEEE 802.1xX, SNMP, BACnet and IP1, IPv4 or IPv6, Active Directory service authentication, HTTPS web server, HTTPS web browser setup, SMTP email client.

USB

Should supports USB. mass storage class devices via the rear panel USB 2.0 host port, and support computer console via the front panel USB 2.0 device port.

RS-232/422/485

For 2-way device control and monitoring, COM port should support RS-232 up to 115.2k baud with software handshaking, one port should support RS-422 or RS-485 and hardware handshaking.

IR/Serial

Should support 1-way device control via infrared up to 1.2 MHz or serial TTL/RS232 (0-5 V) up. to 115.2k baud.

Memory

SDRAM

2 GB Flash 8 GB

Memory Card Supports

Should Support SD and SDHC cards up to 32 GB

External Storage Supports

Should Support USB storage devices up to 1 TB

Connectors and Card Slots

RELAY OUTPUT 1-8

8-pin 3.5 mm detachable terminal blocks; Comprises normally open, isolated relays; Rated 1 A, 30 AC/VDC; MOV arc suppression across contacts

1/0 1-8

9-pin 3.5 mm detachable terminal block; Comprises Versiport digital input/output or analog input ports (referenced to GND); Digital Input: Rated for 0-24 VDC, input impedance 20k , logic threshold >3.125 V low/0 and <1.875 V high/1; Digital Output: 250 mA sink from maximum 24 VDC, catch diodes for use with real world loads; Analog Input: Rated for 0-10 VDC, protected to 24 VDC maximum, input impedance 21k with pull-up resistor disabled; Programmable 5 V, 2k pull-up resistor per pin.

IR-SERIAL OUTPUT 1-8

8-pin 3.5 mm detachable terminal blocks; Comprises (8) IR output ports; IR output up to 1.2 MHz; 1-way serial TTL/RS-232 (0-5 V) up to 115.2k baud.

COM 1

5-pin 3.5 mm detachable terminal block; Bidirectional RS-232/422/485 port; Up to 115.2k baud; hardware and software handshaking support.

COM 2-3

3-pin 3.5 mm detachable terminal blocks; Bidirectional RS-232 ports; Up to 115.2k baud; software handshaking support

MEMORY

SD memory card slot; Accepts one SD or SDHC card up to 32 GB for storage of log files

USB

USB Type A connector, female; USB 2.0 port for storage devices.

LAN

8-pin RJ-45 connector, female; 100/1000 Base-TX Ethernet port.

24VDC 2.0A

2.1 x 5.5 mm DC power connector; 24 VDC power input

Grounding

6-32 screw; Chassis ground lug

COMPUTER (front)

USB Type B connector, female; USB 2.0 computer console port; For setup only

Controls and Indicators

PWR

LED indicates g power is from the operating supplied power pack.

MSG

Red LED, indicates control processor has generated an error message.

HW-R

Recessed push button, initiates hardware reset.

SW-R

Recessed push button, initiates software reset

LAN

(rear) Bi colour.

Power

Power Source Options

Power pack.

Power Pack

Input: 100-240 VAC, 50/60 Hz;
Output: 2.5 A @ 24 VDC.

Power

24 W (1 A @ 24 VDC) with power pack included.

Warranty

3 Years

LINK

LED indicates that DM link is established

PWR

bi-color LED

HDMI IN

Green LED

DM OUT

(LEDs on RJ-45 connector

Controls and Indicators - Receiver

Power

bi-color LED

INPUT 1-2

Push buttons for manual input selection and (2) LEDs.

AUTO

Push button to enable or disable automatic switching

SETUP

Red LED and push button for display of IP address on the HDMI output

DM

LEDs on RJ-45 connector

Ethernet

LEDs on RJ-45 connector

Power Pack

Input: 100-240VAC;
Output: 24VDC 2.5A

Power Consumption

14.8 W typical

Temperature

32° to 104° F (0° to 40° C)

Heat Dissipation

50.5 BTU/hr

Humidity

Transmitter: 20% to 90% RH (noncondensing);
Receiver: 10% to 90% RH (non-condensing)

Warranty

3 years

Power Pack

Input: 100-240VAC; Output: 24VDC 7.5A;

Temperature

32° to 104° F (0° to 40° C)

Humidity

Transmitter: 20% to 90% RH (noncondensing);
Receiver: 10% to 90% RH (non-condensing)

Warranty

3 Years